toolenthusiast's latest activity

There is no room for flat head screw apologists.lol

There are a lot of times that I need to tighten a pair of vise-grips tighter than I can squeeze them. This is especially true while...

Objectively: this is the simple and correct way to achieve OP’s goal Subjectively: I like welding stuff because it makes me feel like...

I just use another Vise Grip to clamp onto the screw to use when wearing gloves, but to get that one right I have to use another smaller...

Learned that trick when I was an apprentice. Needed to do some rough pulls with the monkey on a stick and my mentor showed me a set with...

I've found an eye bolt works too. Add a nut and you can lock the adjuster if needed. My Grip-on can opener uses a wing that works on...

ThisToThat.com Warning: lots of ads

Correct. There are open standards, so 2 brands of connector might be interoperable. But there are a lot of standards.

I don't think there's anything that's a universal pin. Molex/Deutch/DuPont,/JST/Framatome/etc all have slightly different pins.

Your description is good, but this thread would still benefit from pictures

3 things can be learned from this post... 1. Don't buy Subaru 2. VIM sells novelty tools 3. Don't live in snow states

In hind-sight, Is it worth getting the snap-on impact socket for this job? or. put another way, does using your XL DBE from the start...

I'm a huge fan of soldering where it's appropriate. In a vehicle application, it is not appropriate. All wiring in a transportation...