Recent content by Toolmaker

  1. T

    Bend- Pak lifts

    No doubt they are made in China at that price. Just think about it. Look at some of the recent comments on this board about Horrible Freight’s car jacks that are malfunctioning and being returned. They are made in China. I don’t know about anyone else; but I sure wouldn’t go under any car held...
  2. T

    Fire Protection

    The 2 large valves and 2 check valves are for back flow prevention, that is required by city water supply. That confirms that it is a water system. The outside fire connection is for when the fire department shows up they can connect to their pumper trucks to boost the flow and pressure to the...
  3. T

    I'm rich and love to flaunt it! Here it is!

    Cut that purple double barrel slingshot in half,,,, And you’ll have two beanies with head straps!
  4. T

    Correct Quincy compressor for me?

    30 years ago I purchased a single stage 5 HP Speedair air compressor with a 60 gallon tank. Soon after I purchased it I knew that I need to upgrade it to two-stage unit with an 80-gallon tank. If you can find the room go for the bigger tank go for it. And spring for the few extra dollars for a...
  5. T

    Technique for rolling epoxy on the floor?

    I dipped the roller directly into a 5-gallon can of premixed Sherwin William’s 1000HS. Then applied (always in the same direction). Covering an area as far as one dipping would allow with rather heavy pressure on the roller. Immediately followed by a fresh dipping (again in the same direction)...
Top Bottom