Recent content by trdtaco

The floor was back filled watered and compacted. Obviously not enough tho. The garage is 40 by 35. There were no cuts. The contractor insisted the floor did not need it with the wire mesh in the concrete. Obviously Wong again.

We had a garage put on about 4 years ago. In anticipation of having a lift in at somepoint we used 300p tpi concrete and poured in additional thickness where I planned on putting the lift.. So fast forward now 4 years later I have a crack running directly over where the lift was going to be...

Is there a difference between the black, chrome, and gold? Sick of stripping out craftsman bits want to try something better quality jyst don't want to waste money and not get the impact rated ones or if there all ok to use with the hand impact driver

Thanks. Is fowler a decent brand in your opinion?

I'm looking at fowler brand t gauges and set of micrometers. Seem to get great reviews online. I'm looking at the .01mm increment mics. Set of 4 for up to 10mm for 120 bucks seems reasonable with the ratchet stops. This is the cheapest set fowler makes. Same size 0 to 100mm sets go up to 500...

Hey guys I have 3 liftmaster professional openers. My doors are 10 feet wide and 9 feet tall. I have a tension question. The guy my contractor used to install the units told me to always keep the chains on the loose side rather then the tight end. I don't have the manual for the unit but I...

Looking for these torq drivers. Got a bunch marked down and now trying to complete set. The ones with numbers I already have.. Craftsman professional series red and black handles T10 T15 47178 I have T20 T25 T27 48000 I have T30 48001 I have T40 47413 I have Long shank T10 47180 I have T15...

Bump. Last chance. Anyone interested

Need to re home this compressor. I won't have the time or money to re do it right so it's gotta go. It's heavy and big. In Rhode Island 02878

Ya it's super cool. I noticed the China plug too hahaha. It will need some work. The valve cover is broken and either the wheel is not on the shaft right or the crank is bent because the wheel hs a lot of wobble in it.. but it was FREE so I guess I can't complain

Got this compressor a few weeks ago. I thought being a curtis it would be easy to find parts. But can't seem to?find any info. If someone can point me in the right direction would be great

I saw someone's write up on here about using a oil filter relocation kit and running it after the pump to try and keep the debris out of the fluid. So my question is I did this and since used the parts washer 2 times, trailer wheel bearings, and pit bike clean up. And the filter is already...

On the smaller end. Spec of the bore is 1.5 inches.. So either a bore gauge that can handle that small or a 1-2 in micrometer and the gauge. Want quality stuff but not looking to spend crazy money

I use the purple degreaser from home depot. It's the pro one and is safe for use on aluminum which purple power and simple green are not. I also was in the same boat as I am afraid of fire big time so it made the choice easy for water based

Was in there yesterday and today. Lots of good deals left for all you mass and Rhode Island guys..