Recent content by tsagg

Does anyone know the answer to the question regarding the Revolution lifts???

Does the Revolution lift by Rotary require air? The website and literature is vague and not clear on this subject. The BendPak literature wasn't too clear on the subject either until you looked at the installation FAQ. If anyone knows about the Revolution lifts and their need for air or not...

This WOULD be for storage most of the time. my garage is more show than work hence no real need for air tools. I borrow a compressor when I need it. But I guess I'll be buying one if I decide to go with BendPak.

Got to be honest, this seems very inconvenient to have to hook up air hose, fire up a pancake compressor, get it reved up, and use it to lower the lift each time. What are the chief benefits of this type of system vs. the locking mechanisms of the competitors lifts that make this...

What type of compressor do you use? Is it something that you need to have constantly hooked up to the lift? Does it constantly kick on/off ? With the slack lock as a back-up, do you NEED to use the air lock? Just seems like not all home garages where this lift would go into would have air....

just putting this to the top...really hoping for some insight here....

What's the cost of a 3800 installed? I'd love to get my ceiling mounted unit out of the garage.

I'd like to get this back to a discussion about the BendPak lift if i may... I see that the BenPak's need an air supply to activate the safety lock/latch. I believe this is different than other lifts??? I'm not sure but really never thought about needing an air supply. How do you guys set up...

pretty sure I'm going with these above each car in the garage...2 powerful Xenon lights in each fixture. Costco also carries on the web but only in gray...

Thanks! Much work left to do though....never finished!

It's a straight Epoxy floor professionally done with a tan, burgandy and off-white chip. 100% chip spread with two coats of clear on top.

Actually I have a garage restoration business on the side and the cabinets are by a company we rep in the NJ/Philly area. It is not a sticker, or applique, the graphics are IN the product overlay and VERY durable. I chose every picture and with their assistance arranged the design and the rest...

It is a picture of my car that I took and they were able to put on the center graphic board!

Well, the garage needed some work. It's been a dumping ground ever since buying the house 3 years ago. So far just the front wall is finished, the custom cabinets, and floor. Let me know what you think? [/IMG] [/IMG] [/IMG] [/IMG]

I've heard but not seen, that you can cut out some of the angle to the door track taking out, depending upon your ceiling height, some of the angle. So instead of opening and making a near 90 deg. turn and hanging low from the ceiling, it would open, turn less on the new angled track and open...