Recent content by Turbo442

Out of eight blue 44” rollers I have randomly purchased only one is full extension. I have not check the PN’s on the ones I have, it’s quite a bit of work to move them around they are held in place by the steel countertop backsplash. This one is not full extension and needs to be swapped...

I have a 20 HP rotary phase converter in my shop for the last 5 years. I use it to power a Haas VF2 and a Mori 1250 manual lathe. My suggestion is to make sure you size it big enough to handle future growth and have a feed large enough to supply it. If your handy with electrical stuff you can...

I imagine trying to source reasonably priced metric AN hardware would be a nightmare. Sent from my iPhone using Tapatalk

These compressors will run too hot in an enclosed space and usually if your lucky trip the thermal switch on the motor. I have seen compressors in a small room like 10x20 generate enough heat after cycling 3 or 4 times to trip it. Plus the compressor will generate a huge amount of water if the...

I believe it’s an inert Russian anti-tank heat training round. A step above an RPG it can supposedly penetrate a ungodly amount of armor. I saw it and was immediately interested because it appears to have been manufactured by the original arms manufacture. The hardware and machining appears to...

If you get creative you can come up with lots of uses for the new HF tool box accessories. Sent from my iPhone using Tapatalk

I’m assuming it’s relatively new, I haven’t seen them at Home Depot. I have the 1/4 hex brushless as well. It’s the same setup except it has a 1/4 socket drive. It’s super nice for precise disassembly, motorcycles, aircraft, robots, stuff like that. It’s got lots of power if you need it...

This little 1/4 impact is ******** awesome! Sent from my iPhone using Tapatalk

Where the heck did my knipex pliers go darnit... Sent from my iPhone using Tapatalk

Here are some drawer photos as the organization evolves... Sent from my iPhone using Tapatalk

$200 trash compactor...forgot that. And all of the plastic tubs from Costco...that’s was a few hundred. Sent from my iPhone using Tapatalk

I probably have $6k into the total of both work benches. I’m not sure, maybe a little more if I think about the steel tubing for the upper shelves, paint, counter tops, lighting, schaller bins. Probably 7.5k is more realistic. But I think the HF stuff came in around 6k with coupons. Sent...

I had NAPA color match. But you can find nice used cabinets on CL better than what China is shipping these days. But paining is a PITA. Sent from my iPhone using Tapatalk

Time to rip it all out and go with ICON... Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk