Recent content by uk-doctor

my extensions are the straight fix standerd ones, the most force put on the socket was about 100nm to tighten wheel bolts, im really baffled why they are deforming

sorry about the picture thats just how it uploaded, im very sure its not wearing from the ball bearing locking system, its in each corner and has flared the chrome slightly out asif an extension has twisted in the socket. I will try to upload the picture again

I recently bought a brand new set of Snap On 1/2 6 point chrome sockets sizes 12mm - 24mm, i own a full tool cabinet and tool chest of Snap On tools so am not new to tool use. I have only lightly used some of these sockets with ratchets with extensions and the odd time with a breaker bar, I have...

right you are cheers buddy

I consider myself to know tools quite well, majority of my tools are snap on and up to this point i thought that snap on were the leading tool brand in the world for the automotive industry. I was looking online and came across this brand of tools 'nepros' and all this talk about being the best...

ive got the standerd length 1/2 s80a and the longer flex head, ive never felt the need for a locking flex head. not sure why they dont make a shorter length locking head thow but tbf ive never had one

snap on, i dont get why the sockets are holding so loose

Ive got a brand new snap on ratchet screwdriver hard handle black SSDMR4B ''Screwdriver, Ratcheting Magnetic, Standard, Black, 8 3/4" which i bought from a friend a week ago it is unused but does have marks from where i removed his initials but these are not bad atall. I much prefer the soft...

1/4'' deep, 8mm - 15mm all the same, if you put one on and hold the ratchet vertical the socket will droop

haha i will mate, its not causing a problem but for the money you pay for snap on you expect everythink to be secure and strong

is this deliberate or? i would of thought they should hold sockets solid upright with no wobble atall

even the T72?? the socket does not wobble at all? cheers

cheers mate i posted a thread on a tool discussion forum to gather users advice, not to be education in spelling by some smart **** thankyou thow

there brand new off the truck :/ ??

I have the dual 80 series ratchets T72 & F80 they are both brand new and i love them to bits, but i carnt help but notice that the drive that goes into the socket/extension is quite loose on the F80 causing a lot of wobble. Also the T72 when i fix it to a socket the socket wobbles all over the...