Recent content by ukateshka

in meantime I replaced some components like aluminum electrolytic capacitors and Inverter Si7661CJ. Still getting 000 on display :(

Hello people, is there any input on my issue? Waiting for participants.

Hello all again, bad news, after the balancer started working, I just put it on a side for the time I need to use it. That time came, I installed a wheel, turned On the machine, and when I started moving knobs for setting up the wheel dimensions, I heard something like clicks/knocks, and after...

I found a manual for this balancer, hopefully this information will be helpful for someone.

I appreciate that, thank you!

Can I install this type of capacitor instead of Axial?

I'm still thinking to replace these diodes with the KBPC610 KBPC-610 KBPC610-PBF 6A 1000V DIP-4 Single Phase Silicon Bridge Rectifiers KBPC610PBF. You said that you would install one component instead of those four? Can you drow me a diagram how would you install it based on this picture please?

Guys, finally I think it's working now. I installed the new darlington chip and here's the video.(you can hear a noise when the tire is spinning, it's a peace of tire valve inside the tire)

I tried to install weights where the arrows suggest to install, and whe next time I spin the wheel, the arrow shows in different spot. So in other words, I'm always chasing the spot if I add another weight. Is that normal in my case? Also, the LED that wasn't working, it's alive again for some...

Thank you so much for your help with this. I ordered the ULN2068B just in case. Also I thought that under voltage regulator it was an old dry thermal paste, and reapplied a new one but like you said it was a thermal apoxy. Is that ok if I applied regular thermal paste that used for CPUs? Another...

Also checked these diodes

I checked the quad darlington transistor, check out my results. What do you think?

Here's the spec of the potentiometers

Maybe these videos will help to see the whole picture