Recent content by UnkleMike

  1. U

    The Milwaukee addiction thread! :)

    That's exactly what I was trying to say, without actually saying it. Here's the relevant part of my receipt: Sent from my XT1095 using Tapatalk
  2. U

    The Milwaukee addiction thread! :)

    I have the light, and love it. The only negatives for me are the space it takes up in the van, and that you need relatively level ground to set it up. I haven't run it long enough at one time to kill a battery, but after a couple of hours on high mode I still had two lights on the battery...
  3. U

    The Milwaukee addiction thread! :)

    Deal alert:. Home Depot has the Milwaukee Stand Light (2130-20) + a M18 5.0Ah starter kit for $249. It's listed on the web site as a single item (different SKU than the light by itself), but it's also available in stores - scan both items at register and get the cost of the starter kit ($149)...
  4. U

    The Milwaukee addiction thread! :)

    Fyi - I took a look at a display unit in Home Depot today and it had the new clamps. So it appears that the revised clamp design has made it into the distribution channel. Sent from my Nexus 7 using Tapatalk
  5. U

    Home Depot Clearance Thread 2016

    They're not just making the situation difficult, they're allowing the situation to develop in the first place. They created a system in which item prices drop to a penny. Their piss-poor inventory management leaves penny items on shelves for customers to bring to a register. They try to cut...
  6. U

    The Milwaukee addiction thread! :)

    PSA: TrueView Stand Light Anyone with the TrueView Stand Light probably already knows that the clamps that lock the extension poles in position are, well... they ****. The screws that adjust the tension on the clamps need frequent adjustment (at best), or just plain fall out. That's if the...
  7. U

    Home Depot Clearance Thread 2016

    Found these today, but passed on all they had: Not enough margin on the 300lb one. The appliance ones were in the outdoor garden area, covered in debris, bird sh*t, etc - I wouldn't have taken those for free. Sent from my XT1095 using Tapatalk
  8. U

    Home Depot Clearance Thread 2016

    I just left a store where I thought I hit the jackpot - 5 Ridgid 1481 vacuums and 9 Husky 4.6 Silent Flow compressors. Unfortunately PCA had them at $99 and $139! No wonder they still have so many in stock. Sent from my XT1095 using Tapatalk
  9. U

    Home Depot Clearance Thread 2016

    Last week I had an item come up as not found in PCA, but rang up as penny at SCO. I'm not sure if this is typical. Sent from my XT1095 using Tapatalk
  10. U

    The Milwaukee addiction thread! :)

    I use my Fuel impact driver (gen 2) with a 1.5" Bosch daredevil spade bit with no trouble at all. In contrast, I used the same bit with my drill and almost lost my balance (and my hand), and did lose the bit when the bit jammed I'm the hole; the shank of the bit was permanently twisted and...
  11. U

    Home Depot Clearance Thread 2016

    Item not found in PCA today, rang up as penny: Sent from my Nexus 7 using Tapatalk
  12. U

    Home Depot Clearance Thread 2016

    Sent from my XT1095 using Tapatalk
  13. U

    Home Depot Clearance Thread 2016

    Found this in PCA today: No luck finding the actual item though. Sent from my XT1095 using Tapatalk
  14. U

    Home Depot Clearance Thread 2016

    Didn't see this posted, except for the link to SD. Found all 6. Sent from my XT1095 using Tapatalk
  15. U

    Home Depot Clearance Thread 2016

    No, I wasn't talking about returning without a receipt. I meant return for maximum return value stated on the receipt - about $50 when purchased with the combo kit on clearance, closer to $40 when purchased with the hammerdrill kit. Sent from my XT1095 using Tapatalk
Top Bottom