Recent content by UroWerks

No I would never go that far although like I said the hoist looks of decent quality with the stickers removed.Also side note I would never buy anything that's air operated or hydraulically operated by snap off.I haven't had any luck with their air tools or shop equipment.Dont get me wrong hand...

Garage is technically detached separated by a enclosed breeze way and share roof with a ranch style house. Not really a man cave more of a workshop/repair shop for my cars. Hence why im concerned If the 2/3 wire is gonna be enough it doesn't seem so.Once I add lighting possibly more outlets...

Hey guys so I'm trying to get my garage shop build started.I have a question I. Regards to my sub panel,wiring,breakers and so on. So I had a wire run to where's sub panel is going to be.Wire run was 6/3 however I now believe this is way too small for my needs. I know that heating and cooling...

Exterior on the garage is brick,not brick veneer or stone but brick on all sides.So I guess regular roll in insulation should be fine ??

Hey guys it's been a while since I've posted here,but if finally getting around to getting my garage done.It looks like my electrician should be getting started next week.Anyways my garage is technically detached even though it shares the same roof as my house.I have a breeze way that's enclosed...

That's exactly what I did picked it up this morning.Took all the Pittsburgh stickers off and I'd looks rather decent.

It was $120 dollars off the price of a 2 ton

Anyone have a $120 Coupon Off Harbor Freight 2 Ton Capacity Foldable Shop Crane/Engine???I see them on ebay but hard to know wether they are legit or not.I have never seen one.Anyone have a link to one???I need to buy a engine hoist today.

Turn them into clocks and sell them on eBay maybe even make em personalized

I have a quick question how did you anchor the footing your poured for the lift to the exists ting floor?any pics?

Thanks for your input guys.any ideas on how to get the top into like new condition? should unjust clean it and sand???Same for the frame??

Hello all, Today my father in law gave me what looks to be a heavy duty work bench.This thing looks old and needs to be refinished.I don't see any identifying markings on it maybe someone could identify the bench itself? On the corner there's a small plaque it seems as it just has a serial...

Sorry to bring a old thread back to life but it looks like I finally will be putting a scissor lift in my garage.I have a question for those of you that have done it.According to the manual it says the floor needs to be at least 6 inches thick.This is a in ground scissor that will sit flush with...

I would say that scissor lift is the way to go if you have a small space.either a ever eternal scissor or atlas scissor.Can anyone tell me if they are the same lift or not?Im looking at an atlas to put into my garage shortly. Down side?well if you have a car with a frame a scissor is not...

Hey guys im back its been a while,been very busy with work.But I measured my garage its 18 feet wide by 24 feet deep, 9 foot walls with a hip style roof.The garage is framed with 2x6's.I am wondering what is the best way to insulate the walls and roof??Should I just buy insulation, or try the...