Recent content by URTOAST

I did this about 5 years ago, because I had no other choice when it came to space. I ended up removing the drain from the tank and hooking up two flex lines, one from the supply and one from the drain. I ran the drain down to a ball valve on the wall with about a 4 ft piece of pex pipe via an...

:headscrat Ok? I'm not folowing where you are going with this?

Rotary are quite a bit more from what I remember... and to be honest the lift might get used once a month, with a 3K lb car on it... I think a Bend Pak will last a long time under a small load like that, and only used once in a while.... tell me different if not but I thought Rotarys started at...

I would love the larger unit, but i dont have a bunch of room to work with... I will check and see tongiht, but I'm thinking that I'm better off with the smaller unit, even if it takes a bit of time to load a car. I'm mostly into small cars anyway.... Thank you all for your input! Brian

Wow guys thanks! I checked www.e-autolifts.com and there price was also good, and the shipping was included... any one use them before ? It looks to be 2580.00 seams to be the lowest number there is for a HD-9ST model ( The one I want) Now the guy I talked to yesterday seamed to be pushing...

wow thats a good price... Thanks!

I was wondering if any of you guys could tell me the best place to buy a Bed-Pak lift? I want a good price with good service to boot. I relize that the cheapest guy might not always offer good service. But if they do great! Your input is welcome on your experence. Thanks Brian [email protected]

hmmm.... that or I guess I can cut a section out of the celing in the shape of my truck cab, and raise it up, but that might look funky?

I am curently tring to see if I can get one of these to fit in my garage... I have a Mustang that sits at about 54" and a Truck thats at 63" with out the engine in it... and celings that are at 124 inches.... I'm wondering if you know how much you have to raise the lift to un-lock it.. and the...

I relocated mine in my attic, I also removed the regulator, and located it down staires.... I have yet to start mine at this point, but I lost my directions....Does this thing fire up and build presure to what? 90-100-150PSI prior to shutting off? I just dont know what to look for when it go's...

Great...sounds good Thats what I will do! Thanks for the input Brian:rocker:

I have just finished putting my compressor in my attic, the air lines are run, but the drain didnt end up where I wanted it. Does the drain need to flow down hill, or can I run about 25 ft of pipe without sloap, and release the valve with some air left in the tank to force it out? Thanks Brian

Ok I have a question with the smaller units... I got a 33 Gal Craftsman for christmas, I just got a 3/8 50 ft hose reel for the wall on my garage. I have plans on putting it in my attic, and running about 15 ft of pipe down to a regulator/drier/ then up to the hose reel. The output on this...