Recent content by veedubman91

Re: My first post and basement garage build. i work at ottos, and i looked up and sold most of the parts for the restoration of that 2002, but it was a silver one. small world

nice build, very clean

thanks. no i dont, sorry. these are the only other 1 i have after we cut and dug down a little more.

here is my set-up: we cut the floor, dug down a little more, put in new stone, and vapor barrier. then installed 1/2 inch rebar through the side of the existing floor, and into the ground and tied it all together, then put wire mesh in the lower part of it as well. the sides are 12inces wide...

cannot tell, but the roof is vaulted on that side as well, plenty of room to put a car up in

thank you for the advice, i will have to do that. i know that the floor will not look like this forever, but it is holding up very well, im pleased thus far

not as of now no. perhaps it may down the road, but in 3 years it still looks the same it did after we finished it

looks great! i live in Pennsylvania and polished my floor as well. we went to 2000 and i can tell you i have no issues with slipping. i can also say that it has been 3 years of use with this finish and it still looks that same it did when i finished it. my garage is a working garage too, not...

that is a good idea, thank you hmmm, i like that a lot too. going to have to do something soon. thanks for the link Thank you. after this photo was taken, i actually already called you guys and ordered all the trim to finish off around the middle and the upper sides too :thumbup:

well, it has adjustable arms that swing side to side, as well as have multiple locations to put them in. on top of that, they have pads that slide back and forth on the arms for adjustability as well. sorry, those pics i have are with the arms not mounted yet.

thanks. the lift is made by atlas (td6mr model), and i got it from greg smith equiptment. it is rated to 6,000lbs

funny you ask that, i just got my shipment in for the rest of the edging both inside and around for racedeck. i did tie it all in together. we drilled into the side of the existing concrete after the hole was cut and installed 1/2 thick rebar every 5-6 inches. then ran more rebar down into...

depending on how tall you are, you might be able to, but i am 6'1 so i am in between the 2. i have the drain right at the edge, it works, but it is close.

thanks. yeah i agree about the carpet. been looking for a "cleaner" solution to that. for now, it's just temporary untill i find something nicer

thanks guys. gatchel, veedub, and im from downingtown