Recent content by Velocity-Duck

Not sure of the protocol here for requesting help. I've looked through this thread (but not all 61 pages). I've got a ~500sq/ft shop I'm building out and I'm trying to determine the optimal amount of light needed at the workbench. I used 8' florescent tubes in the last shop (10 years ago)...

Not sure about the label on the motor. But for about 15 years it was connected to a 15a breaker and never tripped it. For the past three it's been on a 20a breaker and until about a year ago, never tripped the breaker.

I have a Craftsman 3.5HP, 15 gallon air compressor. Model # 919.152911 Whenever it starts up, it trips the breaker. Reset the breaker and it runs fine... Until it has to start again. Power cord is good, no extension cord in use. Outlet is about 5' from the breaker. I replaced the check...