Recent content by Venom2164

New coupon for this compressor!

I have used an air jitterbug sander. When sanding for 10 minute straight or more the compressor does kick in, but I did not notice a drop off in performance while it filled back up. Same for Paint Spraying. Cut off wheel works well, but everything I have cut was either a small bolt or sheet...

Great advice, Thanks

Lately, I have been doing a lot of painting with it. Shooting oil based enamel onto doors. I bought a foreclosed home that is keeping me very busy. I use the compressor daily for, painting, sanding, blowing, vacuuming, metal work ( Cut off wheel, air hack saw, and nibbler), nail/staple gun and...

Yes, True. Once I had tightened down the nuts to get the anchors snug, I removed the nut and washer, then replaced the metal washer with a thick rubber washer. I put the nut on and brought it down to where it was just causing friction with the rubber washer. It should allow for slight movement...

Ok, recieved this on Saturday. I noticed Solberg has quite a few puck filters along the same line as the #4. Would using a larger model make more noise? less noise?

I always have anchored mine into the concrete and any instructions or install videos I watched always say to anchor into the concrete. I remember seeing posts in another forum where people put them on the vibration pads without mounting them. The compressors moved around and shook to much. They...

Ordered!!! Thanks Again.

Thank you for the Info!

I would like to fit a Solberg #4 to the pump. In fact there was one on the Kobalt I was replacing. The Mount for the Air Pump on the Kobalt Single Stage had slightly different bolt spacing than the Harbor freight Two Stage Pump. I need to find the correct mount so I can screw on the filter...

They are heavy rubber like Car Tires.

you can buy them from Amazon. They don't have those exact model anymore. Here are two links: http://www.amazon.com/PowerMate-Vx-094-0137RP-Vibration-Isolator/dp/B008JVM7G2/ref=sr_1_3?ie=UTF8&qid=1426619138&sr=8-3&keywords=compressor+vibration+mount...

1. I had found this Online: "The Harbor Freight assembled in the USA Air Compressors are assembled in Rock Hill SC. By the Atlas Copco Company. They are from Italy and one of the largest mining and construction compressor makers. The tanks are ASME stamped made by Manchester Tank Company here...

I am still playing with the Drain Timing. At 45 Minute Intervals, water does come out ( a small amount ) but, I think maybe three times a day would be fine. I can add two more sets of on/offs to the Heavy Duty Timer. Then leave the Drain valve set at 45 minutes. The Timer would turn on which...

Just checked... The new one is made by Campbell Hausfeld while the older model was made by US General / Harbor Freight. I would look up some Campbell Hausfeld reviews on the same model.