Recent content by Vernon1969

Trying to add picture that will enlarge sorry always have trouble with this. Here are some of the pictures of the machine all apart.

Speed: Honestly forgot the speed of wheel would have to go figure it out again. But what I do know I started with a 1725 speed motor and speeder up just a little. I'm think right around 2000 RPM's balance: After building it checked for balance and it was so good I left it as is. How the...

I built this handy tool for my plasma torch it would cut a hole even on a curved surface.

Do you have a plasma torch?

Here my Steel Bench Made with a 1/2 plate top 4' X 8'

Looks like a good design and lite

Thank you

Thank you

Most of it was built without to many set backs But the 3 things I started over on or redone was the Sheet Metal guard for the 6 x 48 belt, The arm that allows the 6 x 48 table to tilt, And the last one was the motor mount slide. Saying all that there would be even a few more changes if I did it...

I may drill holes to add a fence thank you

Thank you the weight is 350 lbs so built to last. :)

Been around a shop all my life so I seen things at a early age. Dad had a machine shop out back and I would help him all the time.

I built automatic food machine and Roller coaster. I was pretty much born around a Machine shop. (Dads) I just started drawing a design one day and ran from there. Never drawled a printed kind of built on the fly.

About $1,200.00 Motor, Metal, Bearings, Paint Bolts and Nuts ETC.

Ok I design one on Auto CAD what do ya'll think By the way I'm building this for my homemade belt sander.