Recent content by wedel1

Try Misumi. They have 30x60mm extrusion. https://us.misumi-ec.com/

Convert. Its a conversion tool for all manner of different units of measure, be it length, volume, area, power, ect. Google it.

Let's bring this thread back from the dead.... After much consideration, I think I have an insulation solution for my roof. First layer against the roof will be 1 1/2in foam board with w/foil cut to fit the space between the trusses and purlin. I would use adhesive to stick it to the roof...

Spray foam isn't out of the question but I was looking to keep it a DIY project. I really wouldn't mind buttering the whole thing with an inch of foam to seal it up but $$$ is an issue.

Well, as a positive, no one is trying to talk me out of doing it that way...

Re: Roof Insulation Advice I am familiar with the roof insulation articles posted, those were found in my research, but I couldn't see how those plans would apply to my situation. I was pointing out that I had little to no air intake for venting, a ridge vent, no overhang on the roof, and...

I'm preparing to to insulate the my 30x40 garage and figured I would start with the roof area first. My problem is I don't know exactly how to approach it even after doing research. My garage is pole construction with roof trusses on each pole with 8' spacing. Its not a typical pole...

I would just use your carpenters square. Lay it across the brace figuring the desired rise and run of the support and cut it. Foolproof, no math required...