Recent content by welderwade

can someone tell me what type of float to use in the oil tank by my burner to control the oil level. thank you

do i need a cartridge heater for my beckett burner .i have a heated siphon tank but not a cartridge heater,and i have a hard time to get it to light even at 200f and when it does run for a about 1 hour it will not relight.i run about 5 psi,wmo,when it runs it runs great,can someone solve my...

hi. the main thing to to proper locate axle location which is 60% of your trailer from the front of your trailer not the hitch to center of the two axles hope this helps.....wade

sorry about that...i have a good arc,i have a hago siphon nozzel,pressure around 10 psi,oil level 1 inch below nozzel,nozzel not cllogged,its filtered,3/8 gap thanks for info

hi i need heat but my burner goes out after an hour and will not relight only with furnace oil..i can run temps from 100 deg f to 250 deg f and no change help please ...thank you...

hi ..this is my first time getting it going and it runs for a hour then it will not light up again. if i run furnace oil it lights right up but then i run waste oil and it will not run even at 150 deg c

its a beckett type thanks

i have the oil temp even up to 150 deg c lights good with propane torch but will not light with otherwise looks like i have nice mist..i did have it working in my furnace but it just stopped now i have it on the bench thanks

please help my burner will not light only with propane torch thanks

can someone help my burner with not light only with torch thanks

i have the oil temp up to 150 deg c but still not lighting thanks for any help

hi too all i am new at this my burner will not light only if i light it with it with a torch please help its cold in my shop

thanks is was my trigger

du pont has the best brand of paint on the market and will stand up in any weather for a very long time and not fade like other paints i would not use any other type

hi there..you can not let the paint dry with those types of paint before clear coating because of curing time is very slow it may seem dry to touch but not dry completely so when you put on the clear coat the solvent gets under and open it up....hope this helps