I’m looking for some advice from all you GJ plumbers out there.
I’m trying to figure out the best way to plumb the fill and vent line for a third oil tank. Right now I have two tanks. The fill line directly enters the first tank, once the first tank is full the oil overflows from the first tank...
The aqua stat is in the boiler itself and does have the DHW coil.
My current system is one pump with 2 zones and a valve for each
Correct 2 check valves, one for each pump.
When I think about it, from my experience I can’t really understand why the pump is where it is and why it pumps...
I believe I have finally figured out my plans for my basement heat system add on. But I would like as many second opinions as I can. And I know there’s a lot of good, knowledgeable guys on here. Before you say “whoa, this isn’t garage related.” Just know that my large gun/reloading room will be...
well it seems i got it working. i went down after a while of it running with the hot water control jumped out and wired it back up. flipped the switch and it worked. not sure if it was just too cold or maybe just a dirty connection.
yesterday i tried getting my furnace started up as it will be pretty cold this week. i have an older burnham holiday gas boiler. all the controls are white rodgers.
usually what i do is give it a quick sweep out, light the pilot light manually and flip the switch.
yesterday this what i did...
i went to see if my TS had the Porter Cable sawzall on sale and they were out of stock. but i went over to lowes, showed them the website with the price of 39.99 and they price matched it! boom 79.99 down to 39.99
Haha ya gotta be quick! Personally I don't think their online stock counter works to well. They had a couple of the 5 piece sets left at 89.99 but online it said they had none and the price was still 99.99