Recent content by whateverit takes

I purchased my Motive pressure bleeder earlier this year from an ebbay vendor. I have a few classic cars and a couple with the Wilwood oval master cylinder. I had to buy a few extra adapters. Also the "j" hook and chains do not always provide a leak-free seal to the master cylinder. I added...

I went with a Weaver Pro 10 after my research. My neighbor and I installed it in my newly built 30 x 40 metal shop. It was a lot easier than I anticipated. I have a few classic cars and a 20 Ram 1500 that I regularly use the lift for. It's been in use about 10 months and it does everything I...

I live in NE Florida and recently put up a 30 x 40 metal shop. I installed a shuttered exhaust fan in the west gable which does quite well in removing the heat. I purchased but have not installed 3" bat insulation R-10 custom cut that was $2750 delivered. It came with steel band tape and...

I am in the same exact situation. New to Florida and new-to-me home with leaking roof on existing metal building. My roof has the horizontal-laid roof that allows water to pool and ultimately leak. I tried replacing some of the screws with newer ones and treating the rusty spots where the...

Hello All, Moving from NY to FL and have a shop 25 x 25 metal bldg with two bays. Looking to get ideas to set up shop for hot rod and muscle cars. Former shop was one car garage. Thanks,