Recent content by whipperr

  1. W

    OK first post and its been asked before.

    104MPH.:beer: I was just about to post the web site for you.:thumbup: Then i saw your post. Anyway I was just talking to my dad who is a pretty smart cookie. We really like that idea of useing the back wall. The only problem that we figured we have an answer for is the radeant heater sticks out...
  2. W

    OK first post and its been asked before.

    Photo yes I mesured the bow area thats much shallower than the stern and the doors will open above it. The highest point is the wind deflector. The garage is 12ft high and with the car under there will be 3ft from the keel to the roof of the 300SRT8. I know lots of guys that drag these hulls and...
  3. W

    OK first post and its been asked before.

    I have a shop out back but not big enough. Its -30 to -40 all winter. They want 200min a month to store a boat with out heat. I would have to heat it also. The boat is very expensive over 50 grand made with kevlar over 100mph. I dont want to cause any structural damage freezing the hull. I have...
  4. W

    OK first post and its been asked before.

    Yes I have considered a 4 post lift. I just dont want to have the beems in the center of the garage. I see guys lifting moose and motors up all weigh more than my hull. A moose is over 1000lbs as is a fully dressed V8. Well V8 880 to 950. My hull with the motor off is only 950 also. So if i...
  5. W

    OK first post and its been asked before.

    Hear the boat I want to take the motor off put it on a stand and hoist the hull off the trailer. Illjust park the trailer out back.
  6. W

    OK first post and its been asked before.

    I have a 26x26 garage all free spanning. I looked at some threads on how to hoist stuff to the sealing for storage. This is my plan. I have a 20ft 950lb race boat with engine off. I want to store it up off the trailer with two slings and park the car under it for the winter. The problem is the...
Top Bottom