Recent content by whitexkr

Mike- Is it too mangled to just bend/pry or hammer it back into position ?

Under my Jag, where else? :dunno:

Naah, that was just the excitement of getting your very own lift !!:bounce:

+1, completely agree.

Thanks Joe...I corrected the part number in my post.

OK, here is the the Maxjax with my car at the 'custom' height. The holes above and below are the standard ones. The hole at the very top is for storing the safety support when the lift is down. Almost hate to post a picture of my dinky, sloppy little garage...but hey...it has a lift ! :) I...

Thank you...nice to be here. I pop in here from time to time. It was just about this time last year that I got my Maxjax, thanks in large part to the discussion here. You usually find me posting on jagforums.com. I used this hole saw: http://www.mcmaster.com/#hole-saws/=9v2ehj (the 13/16...

I put a set of holes in roughly halfway between the ones that are there. It was a necessaity because I have extremely low ceilings with ductwork on them. I used a hardened high quality holesaw (21mm, 13/16"). I get about a 3 foot lift..perfect to sit on the floor and work.