Recent content by Wolley

  1. W

    Workbench leg joint help

    Make the entire end out of one or two layers of plywood, similar to a kitchen cabinet.
  2. W

    Craftsman toolbox

    I have a grey one like that. Weights a ton with anything in it. Maybe 20 bucks at a yard sale around here, and good luck selling it at all on CL or FB.
  3. W

    Is the Den of Tools a shill?

    The video should be marked sponsored if it is. Even if he isn't sponsored by tool sellers, he just has to put out enough slop on YouTube to get the views to pay the bills.
  4. W

    Stainless Zerk fittings on greaseable auto suspension ball joints?

    They make a tool to clear stuck fittings. You put it in and hit it with a hammer. Greasing annually isn't enough Unless you are not driving much. I do it the same as oil changes on my truck @ 3k miles
  5. W

    Husqvarna 440 Chainsaw Won't Start

    When the last time it was really run. Must of got pretty hot to melt the plug wire.
  6. W

    QC Oopsies...SK

    They look that way on the grainger website too. Just the way it is.
  7. W

    QC Oopsies...SK

    The whole set looks weird. There is probably zero quality control on a product like that.
  8. W

    Hot tools

    Waxing screws??? What is it 1980. Got use one of these and ditch that Milwaukee.
  9. W

    Shingling Steep Roof Pitch - Strategy Recommendations?

    I just read all this and decided the best course of action is to tear the roof structure off and frame a new 4/12 pitch gable roof so everyone can be safe and not get scared.
  10. W

    Fluid film fun issues/input

    I have that one too. The tip is adjustable to make it spray more volume
  11. W

    Craftsman V-series clearance

    Literally just about everything in Lowe's has a craftsman option. Power tools, lawn mowers, snowblowers, all the carpenter stuff, tool boxes, shovels, rakes, tape measures. Just like the good old days, and they sponsor the NASCAR trucks series and nhra. Kobalt is just about gone in the Lowe's...
  12. W

    Dial Caliper Reading Wrong

    The square slot on the back of the dual is how you re-zero it. You need the corresponding square wire tool to insert in the slot. It comes with the caliper. You need to get the junk out first. GL
  13. W

    5x10 Shed Build

    I've found sheet goods for doors will support itself just fine without any frame work on the inside.
  14. W

    Anyone ever use a 0.0005 Feeler gauge?

    You can use a .001 or .0005 shim to check fixture locations or clearances easier if you tape a small piece to a thicker handle.
  15. W

    Please Splane about Planes

    If the top of the door is rubbing I think you'd be better off cutting off an 1/8 inch with a circular saw then painting it. The doors might move less if the ends are sealed
See more
Top Bottom