Recent content by WoodShopDisaster

looks like the us general box.

I love the gun, its tried and true. Minimal tweaking to the way i normally spray with a sata and i was laying glass.

Just got a IR air ratchet, new clear gun and the GW SAE 1/2 deep socket set on the left in the picture. Also got some birthday cash so I will put it to good use.

Hey guys, I shot a quick updated video of the inside of my box. I just picked up the Kobalt screwdriver set because it was green, didn't need it but had to have it. Sorry there is no talking or explaining, I have this red light syndrome with talking and I go full retard and forget what Im doing...

Yes, there will be bowing, the bottom box will bow. Ill post pictures of my dads setup later.

My dad has this combo as well, i will get some pics if you want. The boxes are so loaded that the weight of the 56 top is actually causing a bad bow in the 72 bottom. My guess is the top doesnt span the box so the weight is resting on a non supported area.

Ill repost again for the love of TDT Yes, i use my tools. Yes, i work out of this box everyday. No, not every single socket gets used from every set, but they look badass in sets dont they? I am a nut with my tools, i keep them clean, dont abuse them and dont lend them out. Just a disclosure...

Lets see more top drawer tuesday, love it!

Top Drawer Tuesday. (I wiped everything down to take this picture, then a lot of my tools got laced in melting snow and salt from todays work.

I'll contribute to the pictures of shavings. I had my wife making see through shavings in hard maple on the living room carpet with no hold downs. Sharp tools are key! I sharpen my blades with oishi water stones 1000, 3000 and 10000 grit. I keep my stones flat with a DMT dia-flat lapping plate...

Did you take those pictures with a potato?

Awesome to see a woodworking thread. I am in the process of moving and will finally have my own detached home shop soon. My old shop was at my parents house. I have yet to build a proper bench, and I have always fought against myself on every project because of that. A real bench is on my short...

I used to use my little snap on magnetic led light inside door panels. On a few occasions I forgot I had the light in there and found it later on still lit up. One time I even finished up a job and buttoned the door all up. I was at my box putting my tools away and I couldn't find my light. When...

Now we gotta know! :dunno:

If you were to buy those three sets off amazon prime it would cost you about $80.65 before tax, so you will save a couple bucks and help get them off your friends' hands. I use gear wrench sockets, I own the sets you mentioned, and you will enjoy using them. Never had a problem with them.