Recent content by WoodsTruck

I think you should remedy that! And pronto!

Question: Did you tilt the pan the same angle as the engine sits in the truck when you marked the 6 quart line?

You are reading my playbook!

I have a little hammer just about like that. I find use for it quite often. One thing I find handy, which Robert might find offense with, is as hammer extender. I can place it where I need to strike, then hit the other face with a second hammer. That way I can minimize impact marks and...

I had a sledding trip to parts unknown in Idaho a couple years back. Small bar for dinner, and lo and behold they had an imported pizza oven. Best pizza in town.

https://fordauthority.com/2026/08/1998-lincoln-town-car-with-1971-ford-f-100-body-up-for-auction/ Just posting here, just because.

Stainless Steel D-rings in the corners of the bed for that occasion that you need to haul something? :p

I was surfing around needatrailerpart.com for the equalizer parts. Decent supply for different dimensions of parts. Some kits, some individual pieces.

I'm shopping for an equalizer linkage setup for my work trailer right now. You should be able to buy a taller equalizer to push the spring mounts a bit lower, or use shorter links. The equalizer, at least the way I see it, keeps the weight split onto both axles when a wheel rides up over a...

Does that model of trailer allow the rear ramp to be folded forward to lay flat on the deck if the trailer is empty?

With a weld on jack mount on each rear corner you should be able to lift the rear of the trailer for a tire change while the trailer is hooked. I need to get some ordered for my work trailer. I hate climbing under a muddy trailer to place a jack under the axle.

Any plans for stabilizer jacks or downriggers in the back corners so the vehicles can be driven off the trailer if unhooked from the tow rig?

Or 14mm in a pinch.

Paint or powdercoat?

I still think there is merit to the collar that Justin machined to act similar to a double shear fastener so the clutch disc is centered using the inside and outside parameters and not being subjected to the slop in the spines.