Recent content by Wowzer893

Just seen this, TSC Canada stores have Dewalt cut off disc onsale in the flyer. they are on sale for .99 cents it's on the first page top right hand side http://www.flippubs.com/publication/?i=241601

I am well aware of what it takes off my shoulders, we work with foster wheeler almost on a weekly basis, I am right now working on a project and I'm pretty sure their bill now is around 100, 000 and we are only in the first stages of revision, this is for an oil and gas project. Honestly it's...

Hello Bill. My name is Drew. and not a problem i'll take some photos tonight, and get some dimensions as best i can and get it posted up

that is the going rate is around here, but everywhere you talk too is a 4 hr min, and you don't get a drawing, stamp or cut list. someone once told me don't know if it's true is every time an Engineers stamp hits the final page is $50

Yeah those where only quotes too i should add, they weren't firm lump some. you pay this and you will have your drawing. in the end i just want to try and do this right. i have thought already about the rotating factor, i am going to get the welding shop in town here to fab me up some...

there's really only 2 in our area, we are kinda remote to any cities. first one was $650, free consultation to talk about it. and then if we pay you get the drawing, cut list, and stamp. 2nd one wanted to come and vist first, okay, and then wanted $725 (Included travel from his office to...

haha Touche sir, you win round 1

haha touche

i haven't done anything yet, haha i am still in the planning and information gathering stage. i can perform this task, and will. i don't have a pocket book that allows me to go out and pay for Engineering, maybe i will have to call in a favor or 2 from my contractor friends who know such...

ohh i'm guessing that all the contents do exceed the 10 psf allowance, no doubt about that one. well tonight, i will try and get some pictures, and such and do a little hand sketch going. and i will def rethink sistersing up the 2x4's now that you have told me they should only be 8 to 9 ft...

i will try get some tonight, can't get into my photobucket to post any pictures

i'm just hoping to put a beam in the center running the 20ft length to pick up some of the load from the attic, this old garage is built with true 2x4 and they are on just over 16" centers for them going the 16 ft side to side. i've tried to post a pic but can't get it to work sorry

the milling machine is this, it's far from Pro grade. http://www.busybeetools.com/products/milling-m-c-mini-110v-mt3-craftex.html

Your not even comparing apples to apples. your comparing apples to watermelon I have the impact, chop saw, table saw, and material to do the job i just don't have the know on what proper 2x6, 8, 10, 12 to use. So your saying if you had the furnace, and controls, and correct T/C wire on...

Could one use this as Air Line, i have an extra roll of it left over from when we did the floor, any one use it in there's...