Recent content by ww3

  1. W

    Rotary lift

    Myers Tire Supply. Bought mine from them. They were easy to work with. There is a branch in Richmond. Lead times these days? Who knows.
  2. W

    Is this the right place to ask about a refigerator problem?

    I had a similar problem with an LG. There is an access panel in the rear about on the middle left for the control board. On that control board around the middle is a reset button. You may have to press it several times. May or may not work but it's worth a try. I did this and the fridge has...
  3. W

    Rotary spo10 wiring

    I have the same lift. There is no whip provided. Main feed goes to the height limit bar switch then to the motor. I used liquidtite conduit with THHN wire.
  4. W

    What type of gasket dressing/sealant for a transmission?

    Mercury Marine Perfect Seal fits the description in your original post. It is brown and remains tacky.
  5. W

    This may sound weird but what do you do?

    Retired RR conductor. Now a burden on society.
  6. W

    liftmaster 3800 finger print pad any one have them?

    Have two. They work fine.
  7. W

    eBay Snap On box....cheap

    This may be of interest if you're close. http://cgi.ebay.com/ebaymotors/USED-SNAP-TOOLBOX-RED-DOUBLE-BANK-/290514757752?pt=Motors_Automotive_Tools&hash=item43a4076878 Warren I was in a hurry. Shoulda checked first.
  8. W

    lifmaster 3800 homelink programming

    Don't forget to press the purple button on the Liftmaster then press the programmed button on the car to sync things up.
  9. W

    DYI Mini-Split 24,000 BTU with tax credit

    Don't know if a cert would be sufficient to maintain warranty. I'm not one who gives warranties much thought. You could do the grunt work and as ghnl did, have a tech evacuate and verify operation. I would think that would satisfy the requirements. I have had the Fujitsu online since May 2008...
  10. W

    DYI Mini-Split 24,000 BTU with tax credit

    Bought it at a local plumbing supply. At the time no EPA certification was required to buy an R410A unit. This still may be the case. I did the install. As previously stated, you will need to pull a vacuum on the lines. Also the proper fittings and adapters for R410A are necessary. I used...
  11. W

    DYI Mini-Split 24,000 BTU with tax credit

    Check out the Fujitsu line. I have a 24000 btu a/c heat pump minisplit with an 18 seer rating. They are precharged with R410A. Warren
  12. W

    Compression - Show Off Your Compressor

    Thought I'd do a first post in the compressor thread. This is a Curtis 80 gal 2 stage 17.4 cfm at 175psi. After using CH and Husky compressors, I decided I wanted a real machine and so far it has lived up to my expectations. Warren
Top Bottom