Recent content by xela456

Hi all, Miller welder question here. I recently acquired a Miller Pipeworx Field Pro 350. I'd like to use this as a power source for a wire feeder. I'm quite aware of the 7000 dollar smart feeder it is intended to run and I know it will run a 12vs extreme. It has a 14 pin connector. I'm curious...

Last I was there I found a 1/2 comfort grip gearwrench ratchet on the floor. I couldn't find where it came from though! Had to price check it to find out it was 50 bucks!

It took a record 17 posts for somebody to bring up a brand you didn't ask about :lol: I've only used a fein angle grinder once. It was long handled and had a strange squeeze type trigger on it. I believe it was meant to keep both of your hand on it at the same time. However it did start very...

Agree with chevelle. It's a flange opener for changing gaskets in-place. Never made since to me though, if ever there was a gasket leaking it needed brushed and scraped off and required alot ore room than that thing provides! As far as the plumb bob, that is something that every millwrights in...

I've passed up in some things due to shipping as well, I dropped the ball on this one. Many years ago I won a bid on a socket set. It was a 425 dollar SK 3/4 drive set. A week went by and no shipping. Another week went by and I finally have a tracking number. I went back and forth over this with...

Yeah Im usually pretty good about looking at the shipping. I guess this one slipped through lol

So am I the only one that does this? Find something you kindof like for a good price and shoot a bid in the dark thinking you'd never win at that price? Well it happens to me semi often. However recently it kindhd duped me. I was bidding on a veto pro tech mtc bag. I bid 65 dollars on it...

Well under warranty I'd think it would be! Id hope. I was just curious if this was just the 2767 being itself or is this am actual problem. I'll try to take it in when I'm not working like 70 hours a week lol. Anyone else grow am attachment to their power tools? The 2763 had been an excellent...

I have several actually, I'll have to check that out thank you, I'd guessed there would be no real obvious problem but I guess I do have a back up so I could send it in.

Has anyone had extensive experience with both? Let me start by saying that I'm heavily invested in the m18 platform. For nearly 5 years I had the same 2763 first gen Fuel High-torque impact. Until about 4 months ago when a thief relieved me of it. It was used very heavily and not once ever let...

It's pretty noisy for sure, and don't let it get wet. I'm on my third one, really the only complaint I have on it is the screw on chuck, I'd prefer the clip on chuck. As far as M12 tools that are totally worth it my list is as follows: Stubby 3/8 Impact for bolts 1/2 and under with a 3.0...

The sky is the limit on these. I didn't know I had such a use for a 90 degree die grinder until I bought one of these I'd start with the 1-1/2 roloc disc holder. From there it's scotch bright pads, zirc flap wheels, polishing discs, and diamond pads. The uses are endless. Your current use for...

Should be fine. Just make sure you get the right end mill as some of them won't cut in the center. I don't know how big your piece is but an aftermarket x y axis would make this much easier. Something like this https://www.amazon.com/dp/B009E0E9YK/?tag=atomicindus08-20

It does, but you only need a piece a little bigger than the bit

Put a piece of cloth between your drill and the sheet metal. It give you a nice round hole. Don't know why but it works