Recent content by Xti04

Hydrangea?

I have 2 of those that need replaced one is not really accessible from the attic side, can they be done from outside on the roof?

Its nothing that some sealant can't fix, just irritated I didn't think of it prior to installation. I did pop open the tent today and perform some minor wiring to get the roof fan up and going. I can run the roof vent fan off a usb- c setup they included with it, so there is one less item...

We had a crazy thunderstorm come thru last night, which has been the norm for this summer. The difference I noticed with this storm as it was coming in, the amount of lightning was intense. It was all within the clouds though, not cloud to ground lightning like we normally see here. I attempted...

After some more digging, I found a Bilstein that should work without the shock extenders. I too, am partial to Bilsteins and have never used the Rancho shocks, though I have replaced quite a few on others vehicles. My parts guy has them inbound for me, the Ranchos are on the shelf in case these...

Congrats Grant! Excited for the Shimano deal!

I have a 15 in 1 Klein screwdriver I added. It was in my center console of my truck. Side cutters were in there, a tape measure, need to make some socket sets up, I snagged a nice tire plug kit not long ago thats already in truck as well. Meter and hammer are good adds as well, I need to find a...

I have previously used the Bilstein 5100s for a leveling of my tundra and my tacoma. The tundra amd tacoma is also a coil over shock setup where my f250 is a separate spring and shock. The level kit is just a spring spacer and a shock extender, but I would rather just get a longer shock to fit...

What is the angle for the tire ban? Improved fuel economy? Reduced mall crawling?

You need to go to the service manager or general manager of the dealership. Thats unacceptable, and the delay it has caused is beyond frustrating. Hopefully they generated a repair order on the car when you took it in 3 months ago which would help you with askong VW if you have to go over the...

I wouldnt say I am an avid reloader by any means, but I have equipment to do it with.

Last night the heat wave finally broke and while Jeff was working in the shop I decided to do some work on the truck the good old fashioned way, lying on my back questioning my life choices. 🙃 These aluminum steps cause a ground clearance issue and are a pain to work around to get the truck...

Time for an update mate!

Wood working vise has been on my list for while. I already have a place for it just havent pulled the trigger on one yet.

Thats what I do when I see one in there. I have learned to turn off the lights when birds come in and I will use blasts of compressed air to push them towards the door.