YoshiMoshi3's latest activity

7 mm - 9 mm = 20.3 mm deep 10 mm - 11 mm = 21.6 mm deep 12 mm is 25.5 mm qe mm is 27 mm 14 mm is 28.2 mm 1/4" bit socket with magnet...

Please list dimensions of the sockets.

I call them female flat heads. Never seen one though in person.

You want me to tell you what you want lmao. Ok brochowsky

I don't know, you tell me.

I got the metric set. Here's a good size comparison to other 17 mm sockets. It may have helped me with rear strut replacement on a...

Lol not trolling, it is actually on my bird feeder. Ok nut vs knob, same thing right? The knob is threaded in there, and goes onto the...

+1! Old school split sleeve tie rod ends is where this tool will come in handy. Especially really old crusty ones. I ordered the Sunnex...

Thanks. I did not trade in my Acura lol. Was just wondering if there was a socket for this type of nut. This confirms that there isn't...

The wings are every 120 degrees because 360 / 3. By the proportions of the thread, and assuming it's hand sized, that thread must be...

I have a tri Wing nut that is meant to be turned by hand, however it is rusted to much to unfasten by hand. Had been sitting outside for...

It works on all modern car inner tie rods. Some are even round and it grips them.

So the Mayhew tool will work on the 8 flat design? I have only removed inner tie rods with a two flat design. Are there other inner tie...

Anyone ever use an outer tie rod socket? Didn't know there was such a thing. Does it work well or damage the stud when you use it? Would...

I have one at work that slips over the tie rod and has a housing with "sprag" type pieces that will grip the inner socket. I don't...