Recent content by youngleo

Still have like 60 of these. I have some at $50 a drawer. Also lots at $60 a drawer

Brake fluid comes in quarts. This backhoe probably has a 40 gallon resevoir for hydraulic fluid. I don't really think that the concentration would be enough to break anything down. Having said that, Hydraulic fluid is 1/20 the price so it really is not even a consideration. Pure brake fluid...

The hydraulic fluid is usually in a very large tank (30 gallons?) that is integrated in to the frame/body. Large pipe thread cap that you will need a wrench to unscrew. It should be pretty tight. Probably leaking a little fluid. Brake fluid works but its pretty expensive and comes in small...

Actually the $250-$300 units are going fast. Sold 4 yesterday to a GJ guy. Another guy coming out today or tomorrow. So, you're right. They are blemished but not beat. So people are loving them. Sold eight in 3 days. Still have over 100 of these available. lots of $350 units. (more...

Just shoot Dave a call. It's my Bday so I'm out today. Also, he gives the best deal. He is at the shop today. It is Two 4 Eight ate 08 zero 936. Sorry for the cryptic word thing. Don't want bots to pick up the number crawling the internet. The matrtix has us lol.

Aslo, in my experience, nothing is beyond repair when it is that rare and hard to make. How bad are they?

We are talking about the same thing. Looks like you have a 1st generation, Lista Deluxe, double wide carriage. Extremely rare in that width. When I need one, I custom fabricate one from a standard width carriage by sectioning it and widening it (all welded). I do have lots of the the...

Yup, the acetylene feather is the hot spot. Pay attention to that.

I guess the “hot deals” thing makes you right. Sorry, still trying to figure this forum out. On another note, I will buy as many as you can find me under $250. 😅 No limit. Also I’d pay a finders fee. I’ll even put some here for cost for GJ users. A lot of times you would have to buy...

I had this exact thing happen and we just sistered another 16 foot member. If you jack up the sagging rafter chord and crown the sister member you should be fine. It should take out the sag. It is fast and cheap. Takes two people though. Get inertia (dead Blow) hammers. They make it way...

I came up with a super cheap and super strong option that takes minutes to install. I just bolted pallet rack uprights to the floor and ceiling then cut the horizontal members to 24 inches I hung the lumber on the horizontal member stubs when attached to the upright. Both sides of the pallet...

I have lots of these. Probably dozens. Send me a picture. There are 3 different variations. I need to know which one you need.

Southeast Michigan. I guess I should have added that? Sorry new to this.

Yes, I did read those before I posted. Also, I was a member a while back. My account is gone now? I am a garage nerd. Last garage had a kegerator, epoxy floors and a rolling door shelf system. I am working on a new project now that I bought a farm. Starting over on the garage. Pretty...

Sorry looks like I posted this in the wrong spot. Such a noob mistake. I reposted in Classifieds. Maybe a moderator can delete it for me?