Recent content by yugami

  1. Y

    Is there any way to use 1/2" inch shank router bits on a 1/4" inch router

    That only has a 1/4 inch collet available.
  2. Y

    Ducted split tired into existing furnace?

    Sounds like I created a weird constraint. I was only thinking of leaving my perfectly functional furnace in place "just in case" But doing a little more looking around I see some pretty good systems for what would be a very quick return based on where my propane prices went to recently. The...
  3. Y

    Ducted split tired into existing furnace?

    I live out in the country so we have propane heat. I've been thinking about the possibility of a central/ducted split system. Where I'm at in Michigan the winter lows can be very unpredictable from year to year. Sometimes a week of -12f, sometimes it never gets below 25f. So it would be...
  4. Y

    Need to move shed to put fence in

    I used a tow truck service, they came out with a flat bed and stuck it exactly where I wanted it for 50 bucks
  5. Y

    Ran out of wire ties

    Nylon gets brittle when it dries out, if you speak them in water they'll be like new
  6. Y

    Question on drill concrete

    If your still thinking about flat bottomed holes Diablo has a SDS Plus bit called a Rebar Demon that creates a not exactly flat bottom, but a much more flat bottom than a spade style.
  7. Y

    Dryer exhaust into attached garage

    Dust Cyclone for bucket
  8. Y

    Green Douglas Fir pre cut studs?

    If you have a cheap moisture meter it would answer a lot of questions. But 4 months isn't a lot of drying time for green lumber.
  9. Y

    Shop Stereo Options; Lets Discuss

    Raspberry Pi with an amplifier running volumio. Will play local music, stream over the local network from the phone or play Spotify. Keeps going no matter where I am or wander on the property with the wifi coverage I have. I run three of them, one in the living room, over in the attached...
  10. Y

    Looking to build a 30x50 garage/workshop - advice needed on options

    I installed a 2 post (the C7000 style moveable) and had them do a 4 1/2" strip that allowed for 2 mounting points at different depths from the garage door. 4" everywhere else. Waited a month to put any weight on it and then parked a F250 in one side and a trailer full of walnut logs on the...
  11. Y

    Looking to build a 30x50 garage/workshop - advice needed on options

    There is literally no reason to go with the extra thick slab your thinking about based on what you're doing, especially with 4000psi concrete.
  12. Y

    New Garage Build - WWGJD??

    General rule of thumb is "go bigger". I went as large as I physically could based on the bills site and budget and still say, I should of gone bigger
  13. Y

    Designing new pole barn 42X32 12ft doors Menards

    My shop which just finished came out to roughly 84K at 32x50 12'8" ceilings (12' walls on an 8" concrete "block"). It was not an easy build site (lots of clay and cut into a hill a little) and has a concrete retaining wall built in to one side. That was wrapped vinyl sided , insulated and...
  14. Y

    On demand water heater not staying hot?

    I have a whole house tankless in my new house. During the inspection we had 2 tubs and 5 sinks running full blast with the water coming out at the programmed temperature for at least 10 minutes. Using propane
  15. Y

    High Output Smart Three Way Switch

    You might need a cross over cable, or of you're using one you might need a regular cable. Cables that come with services that are yellow are typically cross over
See more
Top Bottom