Recent content by Z27

Thanks for the write up and picture breakdown. I think I will attempt to dismantle my Walker 93633. Everything should be similiar.

My son and I did his 3 car with vaulted ceiling with 18 inch wide rollers and it was a real pain. I would definitely try the sprayer routine and use a hand held shield to do around the tracks and whatever.

I posted this once before I think. I went out and bought cheap wood parquet flooring and the appropriate glue. Glued the flooring down and edged with a strip of nice 1X2 brad nailed around the edge to clean up the edge. It probable been there ten years and I use big hammers from time to time...

Checked out the See Snake yesterday. Found a couple of oil leaks on the old Blazer. Its a little odd to work with because of the picture being upside down. And no, its just not that easy to turn it over. I may check out the ductwork next week.

My mother in law got me one of these for Christmas along with 3 extensions. You can do 12' with it. Looks like the head is probably too big for a spark plug hole. I've been looking around for something to check with it.

That looks like a great garage. Plenty of room for toys. :bowdown: What part of Northern Ky are you in?

I bought a Safety Kleen benchtop washer some years ago for $110 with 5 gallons of solvent. Works for most car jobs. Not big enough for a whole cylinder head but I learned to make do. Looks like the price has gone up a bit over the years. This fits well on top of a Craftsman rool around tool...

I've been using the Goodyear orange pliovic hoses from HF for years. Prefer them over the rubber ones. Seem to hold up fine and are easier to coil up when done.

I was looking for a new top for a double wide Craftsman bench. A little bling would also be nice but cheap was important. I went with the cheapest parquet flooring I could find. Came out to about $25 total for a 2' by 9' top. Went with lightest blond looking wood I could find and tacked on a...