Recent content by zeke01

I just relubed a Craftsman ratchet today and used anti-sieze for the lubricant. Zeke01

Thanks for the information. I'm tired of going out to my unheated garage in the winter and having to light a match to see if the lights are on. Zeke

Sorry for being so obtuse but do I understand that you can re-wire your old fixture, eliminating the ballast and the LED tubes will work? Do you have to change the tombstones? My fixtures are 20 years old and use the F40CW tubes. Which LED tubes do you use as replacements? I tried plugging the...

I inherited my S4 from my grandfather through my dad. I remember playing with it 50+ years ago. A few months ago I replaced the bulb in the light(yes, it still has the lens on) put 2 "C" batteries in the handle and it lit up! This floor jack has been a part of my life since about 1959 and this...

Stewart-Warner manufactured vacuum tanks (a precursor to modern fuel pumps) up until about 1930. Although I have never seen anything like this, it may be a diagnostic tool related to vacuum tanks. Zeke

Go to the forums section of aaca.org. Inside that you will find the buy/sell section. You can browse without registering. Register and post if you think it reaches the target audience. Good luck. Zeke

The drum puller is desirable and should bring in the neighborhood of $80.00-$100.00 at an antique car forum such as aaca.org. Zeke

Its used to pull brake drums off of older cars and trucks. A very handy device if you need to do brake work. Zeke