Recent content by Zlove304

I’ve got every thing wired up except for the thermostat wires completely forgot about those

Ok I had it up and running with the pressure switch. I cannot figure out how to wire the auto-off switch and what the two smaller yellow wires go to. They ran out of the motor and were twisted together with connectors on the ends.

How do I have it working two hot wires to the pair of yellow. How would I wire the on off switch and pressure switch. The on off is a 3 prong and the pressure switch has 2 lines in hot and negative and two lines out hot and negative but I have 2 hot wires in not sure what to do there

Further inspection looks like the pair of yellow come off of capacitors green is ground and I have no clue what the other two yellows are

So I have the 2 pairs of large yellow. One large green. Then two smaller yellows that were wired together

Best photo I could HP 7.5 Volts 208/230 Amps 30.0 30.3

Yes they are doing straight from the motor. I will get more pictures in the morning.

Model on the motor is ae07a

Yes coming out of the motor it has 4 large yellow wires two and wired together which I am assuming are the t1-t8 and t4-t8 Then it has a large green wire and a smaller yellow and black wire

Model is

the only thing I could see on the side was t1-t8 t4-t8

It does have a on/off and hour. how would I go about by passing the pressure switch ?

I recently started using a garage that had a snap on compressor that does not work I took the side panel of and the wiring is not good to say the least. It’s a single phase motor does anyone know how I could get it working. The wiring it already ran from the breaker box.