Recent content by zoowho2

I use the .31 rosin/flux core wire and use 110 volt hobart handler. Saves using gas and cleans easily. I love the 110v unit, can take and use it anywhere. For big stuff..the stick welder but I get someone else to move/carry it.

go to mohawk on line for info. I would keep it rather than sell it, it will be a lifesaver at some point for you. New lifts about 5k for starters, usually selling used for 1k or so and compressor anywhere from 150$ to 3k used. But if it is installed and works in good condition..don't sell...

answer is no..go to mohawk for all the lift info you will need. I have the same set up you do and my red car is 40" tall and I cannot use a lift and have room to stand under it and I am 5'9" My p/u truck would have been impossible so at 40" the red car was extremely iffy so I gave up on the idea...

Exlax for starters.... Any set that uses a left hand drill bits, usually removes brokens while drilling. Really, the most important aspect of removing broken bolts or studs is the centering of the pilot hole in the broken fixture. Even a little bit off center and you greatly increase the...

Lots of dunking in wa wa and patience. Get and use a diamond wheel, a bit expensive but a very hard fine grinding wheel used mainly for tool bit sharpening, carbide and other extremely hard metals and use with patience and constant dipping. Fine diamond bits are embedded and remove material...

before I flood the screen with tears, why can't I find these deals. BOO HOO

Large equipment uses much larger chucks and guages. A truck supply company or go online for all the info you need. Air volume is more important than pressure. What good does 100psi do you when you have only a 5 gal tank and 1/4" line. A sand blaster will use massive amts of air that few home...

Not a steal but a good deal if all there. tool holders etc tooling. Motor and pulleys not a big deal. Likley this is a 110V and pully selection equals gearing. A swamp cooler pump motor or low rpm would work. this lathe is not used for heavy industry anyway but really handy for a small shop...

e-bay, weights are inexpensive for stick on, tho they are steel and coated, not lead 300 weights approx 17$

The very best as far as I am concerned, problem is adapters and sizes. Use caution that the rear is not positraction or you'll end up in the neighbors front room. Next is the bubble balancer, the pyramid shaped 3 point level with floater lever. Can be found on e-bay around 150.00. It is what I...

E-bay 150$ found 3 bought 2

cutting torch for sure...drill? in 2 life times maybe