Recent content by Zq8 blazer

Well I’ve purchased 3 openers off eBay that were designed to work. They told me two weren’t in stock and the third they shipped a chainsaw sharpener instead(money was refunded). I went to buy a 4th one from a 4th seller only to receive a message about how they’ve refunded my money so I guess...

Sorry I just now seen this. Currently the doors have locks on the outside that I unlock and the door goes up on its ownsince it’s under tension. Neither of mine have a chain drive. Mine has a solid non turning center pipe and then the black plastic piece which you can see in the picture I...

Thanks.

They rent by the hour too so that’s good. What did the concrete look like when you were finished?

Ok thanks. What kind of finish does one of these floor grinders leave in the concrete? I called and can rent one for a day for $80.

Could you elaborate on the stuf that adheres to the concrete and is like sand paper? Also what kind of shop floor mats are you talking about?

Grind it with a wire wheel? I have a 9” angle grinder and am wondering how hard this is to do?

Thanks! I’m not sure how those will work with mind thoughts the steel tubing doesn’t spin on mine. The black plastic wheel in the middle(as seen in my OP pic) and door itself are the only things that spin on mine. These are the ones I’ve seen that would fit my door, but again I haven’t found...

A few years ago my grandmother had my uncle coat her carport in something from Home Depot and since day one it has started coming off and where it isn’t coming off it is very smooth making it dangerous in the fall and winter due to leaves and sometimes rain/snow will blow under the carport and...

Hi, I have a Carolina Carports garage with dual roll up garage doors. What are my options as far as openers go? All I’ve been able to find so that looks like they’d fit perfect are only sold in Australia, New Zealand, and England while I’m in the USA. This is what mine looks like.