Search results

This makes putting rivets too easy, larger ones (1/4 "peel" type) like Ford uses for door handle latch paddles, not even a snack.

Is the Titan smooth top or diamond plate? I'm not sure about everyone else but I prefer a smooth work surface.

Some really talented people posting on this thread, very informative. A little repair on the cab corner of my utility truck.

You can find these new for about $300, used $100-200, once you have it you'll wonder how you lived without it.

Is it possible to locate the compressor outside?

Definitely the Handy lift.

Very nice work, I did mine with my small Miller XP130 mig, I also have a much more industrial Millermatic 200, on the hitch in my post above it has a little tig welding on the square tube as well. The aluminum float bowl I did that weld with my Hobart HF 250 TR, an older design it weld...

Really neat!! It was always a treat when I used to go overseas to look in the shops, most were more than glad to let you look around when they knew you were from another country. Thank you for your posting Magnusk750.

The float bowl on the right if you held it up to a light looked like a "star map", on the left one I fabricated because I could not find a piece of round bar large enough to machine a billet one.

Some scrap put to good use.