Search results

Picked up a used Wilton 1765 Tradesman 6.5" without base hardware, looking online the original replacement parts alone seem to be more money than what I paid for the Wilton vise. Does anyone know if the parts from a comparable Yost vise are compatible with the Wilton brand vise? Yost parts seem...

I took apart my Arcan 3.25 Ton Floor Jack for servicing after 15 years of use, it felt a bit loose. Overall the Jack did withstand the test of time other then the lifting arm pivot brackets, see below: Look at the wear on that Pivot dowel pin that was welded permanently on there. There was...

Open the side plug today to inspect the tank and found what seems to be lots of surface rust. The rust only seems to be formed on the main body and not the Dome ends. The bottom dome end I couldn't take a picture of but it seems clear expect of the bottom plug that's all rusted (if not more) as...

I have a 60 Gallon Kobalt air compression and I'm in the process of servicing the unit and noticed that there are two styles of compression ferrules that are sealing the main copper pipe between the compressor pump and the 60 gallon tank. The compression ferrule on the compressor side is made of...

Hello, new to the forum. I reecently got an older SnapOn WB260B manual wheel balancer through local listing. I'm hoping somebody here can point me to aftermarket pressure cups that can fit the SnapOn wing nut. Also, what modern machine accessories are these compatible with? I was also...