Search results

I have one of the Harbor Freight auto body stud welders (which I can highly recommend, being the first time I have ever used one). I am using it to fix my Miata race car which has very thin sheet metal. The one issue I have is once done pulling the stud, the roller lock on the slide hammer will...

I have an older Ben Pearson LAS7, once the lift is raised off the locks, each side has a 'L' shaped lever that get pulled to release the locks. As long as the lift is lowered (with the lever pulled) the latch/locks stay unlocked, but if I were to raise the lift, something causes the latches to...

Hey All, I have an odd problem here. I have an older Ben Pearson LAS 7 (lift cable on the floor type). Used consistently, it has very little fluid leakage, after sitting for a month, there was a LOT of fluid on the floor upon the first use and actually squirted across the floor to the wall...

Next Saga Of The Never Ending House Remodel - Getting the LP Gas system running. Been here 3 years and just now able to use gas (don't ask:)). The stove is hooked up and running fine - that's not the issue. I went to start the generator yesterday and it will crank, but not start on LP, >>...

Hello A/C Gurus- My outbuilding has 2 HVAC units that have not been run since I purchased the property (@ 3 years ago). Yesterday I confirmed they will run and I want to get them working; they don't have to be perfect, as I only need something to cool the air in a FL outbuilding (30x60) while...

Hello, I am needing a bit of advice for my lift. I have an older Ben Pearson LAS7 lift. After installing it I found it would lift my Miata just fine, but... then I tried my P/U truck ,and at 7k lbs it will not lift it. The motor starts to make straining, screeching noises then stops lifting...

Hello - getting the collective wisdom the the GJ on this. I have a used BP LAS-7 lift that has no arm restraints, nor does it seem to ever have had any or even any attachment points. I believe I have read that some older lifts do not have these. Am I living life dangerously by not having...

Hello, I have a 30x60 block outbuilding that the previous owner must have done a DIY concrete job. It is unlevel, has footprints, and worst of all, actually slopes IN from the doors. Living in SW Florida combined with the rainy season and roll up doors means that water is always in the garage...