Search results

If there are any A/C experts here, I am in need of some help. I have a Rheem RASL-048JEC condensing unit which has two compressors. Each compressor is controlled by its own board and each board has a Y1 and Y2 connection point. I know the Y1 and Y2 from inside house needs to go to the Y1 and Y2...

My garage floor has been done for a few months but I have a small section (approx. 30 square feet) that has yet to be done. I have enough epoxy left to do the color coat but still need some clear urethane for topcoat. I have been unable to find any retailer that sells it in sizes less than 1...

Three items for sale. Everything was bought solely for the one time use of epoxying my floor and, therefore, were used only once for about an hour. Everything is in great shape. Chicago Electric Professional Angle Grinder from HF 6amp...

So, now I am in a bind. My primer went down this morning. And, as part of my pre-prep for the epoxy-coat I put the hardener into measured containers; one for each batch I am going to do. According to all the instructions I am supposed to have received 2 gallons of color and 1 gallon of hardener...

OK. Here's where I'm at: My garage is 290 square feet and I have 1 full kit of Epoxy-Coat which covers approx. 500 square feet. I just finished priming using Legacy's standard epoxy primer and am gearing up to apply the Epoxy-Coat this afternoon. Does anyone have a recommendation as to whether...

Any recommendation as to the best way to remove paint from the control joints in preparation for epoxy? I grinded the floor with the diamabrush and used an angle grinder for the edges. The only area left to prep is the joints. Is a steel brush sufficient? Sandpaper? Or, is a chemical stripper...

I am nearly set to go on my Epoxy-Coat install. I'm going to start with a prime coat of Aquapon 35 followed by the Epoxy-Coat. However, I am considering a clear topcoat as well. Has anyone topped their Epoxy-Coat with anything other than EC's clear? And, if so, would they recommend it? For...

I ended up getting my grinding done earlier than expected. Therefore, I'd like to get the epoxy done this weekend. Does anyone have any recommended suppliers in S. Florida I could pick up from? I tried Benjamin Moore with no luck but can get SW Armorseal 1000. However, I'd prefer to use 100%...

Just wanted to introduce myself and say thank you to everyone who has made this such a great forum. After living in condos my entire adult life I finally got a house with a garage. Now I'm fully immersed into personalizing it and DIY'ing as much as I can. This site has been invaluable as I gear...