Search results

Finally got a floor!! It's 1/8" x 34" x 48"

Wouldn't you want a tray to catch the slag?

Thanks for those!! Kevin54

Kevin54, I would like dimensions of your 5 ton press

1st: My dumping pin. 2nd: I used 1/4" x 1-1/2" flat to reinforce the tongue with a 1/2" bolt 3rd: I used 1/4" x 1-1/2" flat 16" long with 2 1/2" holes for my lever. 4th: Is how its to look when the lever is in place Deciding on to use yoke ends or not to connect the lever and pin.

Nice Table!!!

Here is the tongue I sectioned out for my dump lever. It's 4 1/2 x 1 1/2 with 9/16 holes. I will use 1/4" steel to reinforce each side and 1/4" lever.

I trying to find the right media to use also.

HELP!! Need advise on how I should mount my dump lever. Should I notch out the tongue and support the inside or mount it on top of the tongue?

Very Cool!! Just like your table!!

this is one I made its a 30x 30x 3/8" legs are 2x2x 1/8" 34" long with channel support of 2x 9/16x 1/8"

Here is what I have:

Here is the wheel view

Needing ideas for my lever to dump. It will be located up by the tractor.

The round stock is loose it goes all the way through. I used the extra axle hubs from my tractor and a bushing between the hub and frame to keep the hub from digging into the frame.

Heres what I have so far!

Well I'm building a trailer similar to this one I found surfing the net.

Very Well Made!!! Absoluty liked reading and seeing all the parts you made and how it came together!