Search results

It looks my next shop project will be replacing the cylinder on an old 20 ton press. I will be using an air over hydraulic cylinder, probably from everyone's favorite Chinese tool store. I went searching for a foot pedal to operate the cylinder and I am overwhelmed by the choices. Can someone...

I recently acquired a used Mac 1800/1850 combo. The previous said he had replaced the lid struts with some he got at Autozone. Can someone with this top box measure the struts at fully open so that I can compare what I have to the originals? I'm just wanting yo make sure the lid will open all of...

Does anyone out there have the Mac fine tooth spearhead 3/4 drive ratchet and can provide feedback/review? It looks it would very useful with the tight arc. Looking around it seems like it is a rebranded Facom ratchet. I'm a DIY guy and not worried about warranty.

Hey yall, long time lurker here. I recently came in to possesion of 9000# 2 post rotary lift. I am almost done with install but hit a snag, one of the 3/4wedge anchors wouldnt tighten and pulled completely through the hole. I am sure this would be a good place for epoxy but I dont know enough...

Hey yall, new guy here. Life long tool junky. I think I got my first tools as Christmas gifts when I was 12ish. Dad got tired of me "borrowing" his, you know the story. Also a military veteran (USN 1991-1997 [2192 days, not that I was counting]) Looking forward to interacting with yall Scott