Search results

I know this is a highly debated subject and I can understand both sides. I will be replacing my forced hot air furnace and putting in some form of better particulate cleaning than an EAC. Before subjecting new filters and coils to the existing (mostly steel) 30 yr old ductwork, should I...

I will be replacing my old forced hot air up-flow furnace shortly with a new furnace that I have waiting in the wings. New furnace will sit on 4" concrete blocks which creates some ductwork adjustments in the return. New plenum is already made. In reviewing my existing EAC against new units, I...

I'm looking for a simple through-the-wall overhead service lateral attachment clevis. I can't find them with a long enough bolt or large enough diameter. I need this arrangement but with a 10-12" 5/8" threaded bolt.... I'm only finding 3/8" x 5" long bolts. The existing o/h service...

I am preparing to replace a NG upflow furnace, A coil, and compressor. The A coil enclosure is 21" sq and can "fit" in any 90 degree position on top of furnace enclosure. The manual eventually indicates ref lines and drain lines on the same side as furnace access doors and vent lines. Also...

Anyone with experience on either of these adapters? Looks like the simplest way to meter a seperate rate for EV Chargers or solar. My POCO just approved these for use this year. I know there was a xfer switch type adapter several years back but that wasn't approved for use. Looks pretty close...

Two questions: 1) I am looking for a toggle style dimmer with 0-10 volt dimming function. All I can find are slider and rocker style. Anyone know of a toggle style? 2) I saw a dimmer spec that stated: 28mA maximum sink current. What does a typical fixture's 0-10 volt dimming input draw? (This...

These are fan motors on o/h gas heaters. Many motors have been improperly replaced over the years and have flying splices that need correcting. Does anyone know where to get this custom style connector from, what it is called or who is the mfr? Thx

My air compressor locked up yesterday after running low on oil due to leakage past the piston. My compressor head is locked up and I am in the process of tearing down/cleaning up to be ready for a replacement. So as I bleed the tank, what was normally just water is now alot of oil and a little...

Recommendations for field tested rechargeable led work lights - Can anyone provide field tested/proven recommendations for rechargeable led work lights - both handheld and stationary versions. Looking for something convenient when doing electrical service changeouts and general...

Last set of files!

Next set of files

After searching the web for rebuild parts for this jack, I found Hiball's write-up on rebuilding imports. It was very helpful before I ripped mine apart. Since identifying a supplier for a rebuild kit was the biggest problem, I figured I'd share my learnings for everyone else who owns one of...