Search results

had a job that required a lot of notches in tubing. i have wanted a better way than angle cutting and grinding so after a little research on various designs and a look at the scrap available this is what i came up with. started off by cutting off a piece of 2" plate remove metal till you have...

here is a press i have been saving up scrap steel for for a long time. press will be 50 ton and so far i have purchased no steel for it which has dictated the design. original calculations showed the table was going to be very close the the bending state so i put the x bracing in it and the top...

new guy from central square, n.y. putting together the plans to make a garage/shop and was given this site. recently purchased a 33.7 acre lot and planning to build a 48X78X18 pole bldg with in slab heat. i have lots of questions but will do some searching first so i don't waste a lot of your...