Search results

My main grinder is delta 8". But my little old craftman 5" died last night. It was actually my 1st power tool I purchased 1985. I was 14. So in the market for a new grinder for buffing and wire wheel. I'm thinking getting 2 one for wire wheel and another for buffing duties. I have little hf 5"...

Picked up this guy for $100 even. Dayton miter band saw. This was basically new in the box. Handle and trigger switch was broken. Link to saw. http://www.grainger.com/Grainger/DAYTON-Portable-Bench-Miter-Band-Saw-2LKT7?Pid=search My repair for the handle and switch, well it works.

I have my grandfathers old table saw 1974 9" craftsman table saw. The cast table was rusty and pitted. Used a wire wheel and flap disc to remove the rust. I think that was a mistake. Surface is a uneven now. You can see the flap disk marks. What can you guys recommend to even out the surface...

Hello, looking for ideas for a smaller bench vise to bolt to small 20x24 folding weld table. Basically carry/roll into building do the job pack up and go. Maybe someone can recommend specific older models to be on the lookout for. Would like to keep it under 30 lbs