Search results

I have a Jet Model JMD-15 mill. About 7-8 years old. I want to add a power feed. Amazon's full of them, but I'm looking for suggestions. Must be 120V. Thanks Jack

I have a 3200 sq ft very well insulated shop with both in floor heat and a 95% 100,000 btu furnace/AC. I work in the shop 1.5 to 2 hours 3 or 4 nights a week and 5 - 8 hours on Saturdays and Sundays. I'm trying to decide which would be more efficient, set the floor heat to a constant 65 deg. or...

I need to acidize my floor before coating w/ Rust Bullett. My floor drain goes to my septic tank. Will the acid hurt the septic process? Thanks Jack

What size wire and breaker should I use for a Nordyne 4 ton 16 SEER condenser? Manual lists Total amps as 23.7 and minimum circuit ampacity as 29.0. Distance from breaker panel to disconnect is 35'. For my 5 ton it's total amps 31.4, Minimum ampacity is 38.6. Distance will be about 60'...

I'm spending way too much to get tires mounted. Any suggestions for a good tire machine in the $800-1500 range? I need at least 19" diameter and 13" width. Thanks Jack

We're installing 1-1/2" foam board under our basement slab. There are a few places around the floor drain, closet flange and sewage basin and the footings where there are small gaps in the foam board. Should we try to seal those with spray foam. Do you need to tape the seams? Thanks Jack

I have a 3PH 6 ton package unit. Any easy way to use it on 1PH service? Thanks Jack