Search results

so one of the journeyman that I supervise was working on a electric vehicle charging station. he needed to take a cover off which was held on with a torx t25 tamper proof screw. the kicker was that it was recessed about 3 inches in the housing and a multi tool kit with interchangeable bits would...

currently i have a jd model 2 hydraulic tube bender with about 3 full sets of dies, the PO had it set up in his large shop and he built it so that it sits on a 3' x3' base with casters. the over all heght is about 4' to the top of the ram. its a good setup however at 3'x3' it does eat up a lot...