Search results

Hello, I have a Greenfield tap and die set and I'm looking to see if anyone can tell me what it's worth, more or less. Label says U.S. Screw Threading Set NSN 5180-00-422-4975. Unfortunately can't find much more information on it than that. Seems to be missing the 5/8 die as well. Other than...

sold

F/S: Tool Vault 72" x 25" Deep 19 drawer Roller Cabinet + Matco/MAC/SK tools I'm moving out of the country and need to sell my toolbox and all of my tools. I'd prefer to sell the entire box and the tools, but if someone wants to buy an entire drawer of items let me know and we'll talk...

Hi Guys, I'm moving and I need to sell an entire tool chest, and I don't have time to sell each set of tools individually. I just want to sell the whole thing. I'm guessing I can try craigslist and facebook, but is there somewhere else I can try selling this thing? Don't really want to deal...

Hi Guys, I have an air compressor in an installation where it doesn't run very often and it tends to get a lot of water in the oil. It's a large compressor (7.5 hp, 120 gallons) and when I bought it I used a lot of air but right now it barely ever runs except to compensate for air loss in the...

Hi, I'm trying to connect an air compressor to some compressed air line using a flexible jump hose. The problem is none of the fittings on the jump hose rotate and I obviously can't rotate the compressor or the lines so when I tighten the hose it's trying to bend :headscrat How are you guys...

Hi Fellas, I want to run 100 amps from a 200 amp main panel to a sub panel in another location in my shop. I'll run it in conduit from the main panel, leave it exposed in the rafters, and then back into conduit to go into the sub panel in the other side of the shop. My question is what type of...

I had a question about 3-phase and wanted to figure it out before I even bother calling my local POCO about getting the service. From what I understand, with a 4 wire 3-phase service, any hot leg to neutral is 120v. Like most shops I have a variety of single-phase 120v and 220v machines that I...

I was running a sub from my ancient main panel and noticed some white **** above the lugs in nearly all of the ancient breakers in the panel. On the new breaker I put in there is just a square with plastic film over that area so I'm guessing this is some type of corrosion and probably bad. Can...

Hi all, I'm running a compressor and a welder with two branch circuits off my main panel right now and I'm trying to decide if I should just run a sub panel. My compressor is 5HP and my main panel is more than 50' away so I need to add a disconnect near the compressor to get it up to code, so...

Hi Fellas, Anyone have any experience with pneumatic angle grinders? I'm using a dewalt electric 4 1/2" angle grinder to remove millscale and it gets damn hot after a while (sidenote: I just got an 80 gal compressor so I'm looking for an excuse to buy more air tools). From looking at the...

Saw this on their facebook and thought my fellow GJ'ers might want to take advantage: http://tools.woot.com/plus/astro-pneumatic-our-pneumatic-future Picked up a set of the hose clamp pliers, was $10 cheaper than on Amazon.