Search results

Looking to seal my shop floor. Concrete is about a year old and relatively clean. Looking at the Legacy HD 39. Any one have any experience with this product?

I am getting ready to insulate the ceiling in my pole barn. It is 30x40x10 with attic truss and the floor for the attic has already been installed so blow in insulation is out. I was planning on going with R30 faced. If I go with faced insulation do I need to put a vapor barrier on the lower...

I am in the process of finishing the inside of my pole barn which is 30x40 with attic truss. It will probably be next year before I can install the ceiling which is going to be steel. I was thinking of putting up plastic on the bottom of the trusses and blowing the insulation on top of the...

Ok I have been doing a lot of reading here before I posted up so I may have this some what figured out just want someone to check my thinking. I want to run 100 amp service out to my pole barn I have 200 amp service at the house with room in the panel. I have 2" PVC run under ground with long...

Well the site is ready after cutting down countless trees to make room. Very jealous of you guys with flat ground to work on! Will be used mainly to support my dirt bike addiction. They are scheduled to start building this Thursday.

I started lurking here when I bought my house about 7 years ago. When looking for a house a garage and 5 acres was the requirement. That didn't fit the budget so I ended up with a house and no garage on 8 acres. I figured in a year I would have a shop built.... Well here it is 7 years later and...