Search results

I'm wiring up the recepticles in my shop. I'm running #12 thhn wire in 1/2 inch emt. The emt runs from the breaker box to junction boxes, then down to each recepticle box. My question is do I need 6 wires going to from the junction box to the recepticles. 2 hot, 2 neutral, and 2 ground...

I have some t5 lights that I plan on wiring in my detached accesory building. I have six of them total that I plan on running on 3 switches of 2 so I can save on energy and just use 2 of them at a time. My first question is should I be fine running all of them on the same 20a circuit...

I just had a new meter installed at the pole with disconnects. It has a 200amp disconnect for my house and 4 extra knockouts for extra breakers. I plan on running Mhf 2 2 2 4 from the meter to my shop 60ft away. I know the 2 hots will go into the 90A breaker I'm putting in but my question...

I plan on running 100a service to my pole barn from house. From what I've read I should use 2 2 2 4 ser/urd In 2 inch conduit. 100a breaker on pole barn panel and 90a breaker on main panel in house side correct? The panel in my house is a bryant which I think is no Longer in business...

Hello, I'm looking for some advice on running Electricity to pole barn. It's about 100 feet from My house. I plan on running a 60 gal 5gp compressor And 2 post lift. I've searched a little bit on using the Mhf 2 2 2 4 and 90 amp breaker and what not but It may be just a little over my...

Pretty happy with it. Still have electrical to do. The pad took about 75 tons of dusty buckshot And 50 tons of gravel to get everything level and Prepped for concrete slab. Slab is 4 inches with a couple Thicker areas for a future lift. Relief cut as well

Hello there, I'm new to the forum and was hoping to get some suggestions from you all on which way to go. I'm wanting to have a 30x40x12 garage built. I have a budget of about 21k to work with. I would like to go with a stick built type garage and plan on putting a lift in it sometime in...