Search results

  1. A

    Grizzly H8089 Low Profile Transmission Jack

    I have a Grizzly model H8089 Low profile transmission jack. 1250 pound capacity. Jack is in very good condition. Some surface rust from storage in garage, but other than that it is ready to go. Save your back and get this jack! $90 OBO. Local pickup only. PM me if interested. Thanks, George
  2. A

    Wiring A Reznor UDAS Heater

    I'm currently running the wiring in my garage in anticipation of installing a Reznor UDAS-30 heater. According to the installation manual: "A dedicated line voltage supply with disconnect switch should be run directly from the main electrical panel to the heater. All external wiring must be...
  3. A

    Reznor UDAS-30 Heat Exchanger Material

    I'm planning on installing a Reznor UDAS-30 in my 2 car garage. Any thoughts as to whether upgrading from the standard aluminized steel heat exchanger is worth the extra coin? I realize longer life of the exchanger is probably to main benefit. 409 stainless would be an additional $394 and 316...
  4. A

    Securing Cable from Conduit

    Expert Sparky's, I've made progress getting my previously flush mounted box switched to a surface mount. I used 1/2 inch plywood secured to the studs and mounted to subpanel to the plywood. I used a 2" conduit (secured with 4 clamps) from the panel to about 8" above where the ceiling...
  5. A

    Sub Panel-Flush to Surface Mount

    Hello Garage Electrical Guru's I had a sub panel installed in my garage by a professional electrician at the same time my basement was finished a few years ago. The feeder cable from the main panel enters through the back of the sub panel. I've finally decided to finish my two-car attached...
Top Bottom